Maintenance and Operation

Maintenance

After installation, this folding partition requires very little maintenance.

Should some roughness develop in the supporting track when moving the panels, wipe off the inside of the bottom lips of the track on both levels with a rag. When clean, apply a small quantity of light grease to these lips at intervals across the full opening and stacking area.

Operate the panels across the opening to evenly distribute the grease along the track
If it is necessary to clean the fabric, use warm water and soap, with a soft scrubbing brush. Avoid chemical cleaners or strong detergents.
Should replacement parts be required, or for other information, contact your nearest Corflex distributor

Gently slide out 1st panel from stack bundle into main track (Fig.1)
Gently push panel to far end opposite to stack (Fig. 2)
Place operating handle into trail end of panel and turn half revolution to lock top and bottom mechanical seals (Fig.3)
Repeat steps 1 to 3 with remaining panels
When all panels are in line across room and seals are locked, swing hinged closure panel to closed position in line with all panels (Fig. 4)
To stack folding partition, reverse above steps from 5 to 1

Gently slide out 1st panel from stack bundle into main track (Fig.1)
Gently push panel to far end opposite to stack (Fig. 2)
Place operating handle into trail end of panel and turn half revolution to lock top and bottom mechanical seals (Fig.3)
Repeat steps 1 to 3 with remaining panels
When all panels are in line across room and seals are locked, gently slide out lever closure panel from stack to main track
1. Gently push lever closure panel against last panel
2. Place operating handle into trail end of panel and turn half revolution to lock top and bottom mechanical seals
3. Place operating handle into opening on face of panel and turn to expand nose against wall to seal folding partition (Fig. 4)
To stack folding partition, reverse above steps from 5 to 1